3
Display Time
To save battery power, the watch will automatically switch to standby
mode after displaying the time page for more than 10 seconds. This
means that the screen will still display time, but the GPS chipset will be
deactivated. To reactivate, navigate to another screen using any buttons
except the power button.
NOTE:
The watch will automatically set the time according to GPS
satellites. However, you must set the correct Time Format, Time Zone
and Time Mode by navigating the MENU Screen.
Use the Up and Down buttons at the right to navigate through the MENU
page. Once there press the OK button (lower left of the watch). Use the OK button
again to select SETUP, scroll up and down to select SYSTEM and then TIME. You’ll
be displayed three options: the Time Format (12h/24h), the Time Zone and the Time
Mode (Standard or Daylight Saving). Make your selection and use the RETURN
button (upper left) to go back to the main menu.
To Use the Heart Rate Monitor
If you don’t have heart rate strap, ignore this section and jump to
“
Start Your Workout
”
If your product comes with an Ant+ heart rate strap, attach the transmitter
to the strap. To start monitoring your heart rate, pair and sync the heart
rate strap to your watch using the watch menu:
Enter the MENU page, select SETUP then SENSOR. Put the Heart Rate strap
around your chest, directly on your skin.* Now select CARDIO. The watch will
automatically detect the Ant+ transmitter and display your Heart Rate. Use the
ESCAPE button to exit and return to
the main menu.
NOTE: As with every other watch configuration, the pairing and syncing
between the watch and the heart rate strap will be saved until you reset the
watch parameters or install a new firmware.
