Energic Plus TST-D, Руководство по эксплуатации

Страница: 14 / 19

If this error message appears, it’s recommended to call (for service) for a complete check of the system .
The cause if this problem may be a wrong setting of the input voltage: if the input is set to a
certain value (for example: 610 V) but the real voltage is lower (for example: 575 V), the
charging current will be significantly lower than the nominal value, therefore it will take more
time to reach the gassing voltage .
AUTOMATIC DATA SAVING
• If, while the charge or the equalization is in progress, a black-out of the AC input occurs,
the charger saves automatically all the relevant information about the state of the charge .
While the input power is absent, the message “Black Out” is displayed:
• When the power supply will be available again, the charger will re-start automatically from
the exact point of interruption, and the charge will be normally completed .
AUTOMATIC AND MANUAL CHARGE TERMINATION
CAUTION!
NEVER disconnect the battery while it’s being charged.
Disconnecting the battery while it’s being charged is hazardous for the user and
voids the charger warranty.
• AUTOMATIC CHARGE TERMINATION:
When the charge has been normally completed, the charger turns off automatically .
The display shows the flashing message “End” .
At this point, it’s possible to disconnect the battery .
• MANUAL CHARGE TERMINATION:
The charge can be manually terminated in any moment, by pressing the red STOP
pushbutton . The display will show the message “Stop”:
At this point, it’s possible to disconnect the battery .
14