Energic Plus TST-D, Руководство по эксплуатации

Страница: 3 / 19

SAFETY INSTRUCTIONS AND WARNINGS
Before you start using your Energic Plus battery charger, please take the time to read these
instructions carefully .
The owner’s manual is an important part of the charger . It’s recommended to keep it in good
condition for the lifetime of the charger . It should be kept in a dry and clean place, always
available to the users .
To indicate important instructions, the following blocks are used throughout this manual .
CAUTION!
This operation can be dangerous for the user.
ATTENTION!
This operation is important for the functionality and reliability of the charger.
GENERAL
Battery charging products can cause serious injury or death, or damage to other equipment or property, if
the operator does not strictly observe all safety rules and take precautionary actions . Safe practices must
be learned through study and training before using this equipment . Only qualified personnel should install,
use, or service this equipment .
SHOCK PREVENTION
Bare conductors, or terminals in the output circuit, or ungrounded, electrically-live equipment can fatally
shock a person . To protect against shock, have competent electrician verify that the equipment is adequately
grounded and learn what terminals and parts are electrically HOT .
The body’s electrical resistance is decreased when wet, permitting dangerous current to flow through the
body . Do not work in damp area without being extremely careful . Stand on dry rubber mat or dry wood and
use insulating gloves when dampness or sweat cannot be avoided . Keep clothing dry .
INSTALLATION AND GROUNDING
- A power disconnect switch must be located at the equipment .
Check the data label for voltage and phase requirements . If only 3-phase power is available, connect sin-
gle-phase equipment to ONLY TWO WIRES of the 3-phase line .
DO NOT CONNECT the equipment grounding conductor to the third live wire of the 3-phase line as this
makes the equipment frame electrically HOT, which can cause a fatal shock . If a grounding conductor is part
of the power supply cable, be sure to connect it to a properly grounded switch box or building ground . If not
part of the supply cable, use a separate grounding conductor . Don’t remove a ground prong from any plug .
Use correct mating receptacles . Check ground for electrical continuity before using equipment . The ground-
ing conductor must be of a size equal to or larger than the size of the line conductors .
CHARGING LEADS
– Inspect leads often for damage to the insulation . Replace or repair cracked or worn
leads immediately . Use leads having sufficient capacity to carry the operating current without overheating .
Don’t replace the original cables with longer cables . Don’t use additional cables to lenghten the original
connections .
3