ENERGIC Plus
AR-TOP [V.140 – January 2011]
USER'S MANUAL
___________________________________________________________________________________________________________________________________________________
BATTERY VOLTAGE TOO HIGH
If the battery voltage is higher than a maximum threshold, the charge will not start and the display visualizes
the message:
If this message appears, it's recommended to verify that the nominal battery voltage matches the nominal
voltage of the charger. Probably a wrong battery has been connected.
BATTERY VOLTAGE TOO LOW
If the battery voltage is lower than a minimum threshold, the charge will not start and the display visualizes the
message:
If this message appears, it's recommended to verify that the nominal battery voltage matches the nominal
voltage of the charger.
Probably a wrong battery has been connected.
It's also possible that the battery has been deeply discharged, bringing the voltage below the minimum value
required for the automatic start the charge.
In this case, it's possible to override the warning message and to start the charge manually, by pushing the
button DOWN for 5 seconds. The AR-TOP will activate an automatic DESULPHATION-RECOVERY cycle,
after that a standard charging cycle will begin.
CHARGE CYCLE
When the preliminary controls are complete, the charge starts automatically, and the display visualizes the
following information:
•
Battery Voltage
[Volt]
•
Charging Current
[Amps]
•
Time of Charge
[hours.minutes]
•
Capacity Returned
[Ah]
__________________________________________________________________________________________________________________________________________________
Page 19/32
BATTERY VOLTAGE
TOO HIGH !!!
BATTERY VOLTAGE
TOO LOW !!!
xx.x V xxx A
xxx Ah x.x t
