ENERGIC Plus
AR-TOP [V.140 – January 2011]
USER'S MANUAL
___________________________________________________________________________________________________________________________________________________
5. OPERATION
CONNECTION OF THE BATTERY, AUTOMATIC START
Connect the Battery to the charger, using a connector of adequate size.
When the battery is correctly connected, the charger visualizes the following message:
WIRELESS CONNECTION TO BATTERY IDENTIFICATION MODULE (OPTIONAL)
If the Battery Identification Module is enabled, a few seconds after the connection of the battery, the charger
will try to establish a wireless connection. And the display will visualize the message:
When the wireless connection is active the charger is ready to start the charging cycle. The display visualizes
the message:
At this point, the battery information are transferred to the charger and are visualized on the display.
The charger is now ready to start.
Depending on the programmed start time window (Parameter 8), the charger may enter in stand-by mode, and
the display visualizes the message:
Where (hh.mm)A represents the real time at that moment, and (hh.mm)B represents the programmed start time.
When the charge begins, the display visualizes the message:
__________________________________________________________________________________________________________________________________________________
Page 18/32
BATT ID MODULE
SEARCHING...
BATTERY
CONNECTED
BATT ID MODULE
CONNECTED
PREPARING
TO CHARGE
DELAYED START
(hh.mm)A → (hh.mm)B
