Eneo DLR-1004/500V, Руководство по эксплуатации, Страница: 39 / 64

4-Channel Digital Video Recorder
31
Turning Zone View On will allow you to observe how the DVR is reacting to motion. When in
the motion viewing mode, any detected motion within the zone will be displayed in red.
You can control excessive event logging and remote notification of motions detected after the
motion dwell time by adjusting the motion ignoring dwell intervals. Highlight the box beside
Motion Ignoring Interval and press the button. A list of intervals ranging from 1 to 5 seconds
or Never appears. The DVR will not log and notify motion events occurred during the preset
interval range.
NOTE: The record action for motion events will not be affected by the Motion Ignoring
function.
Highlighting the Daytime Setup… box and pressing the button allow you to set up the Daytime
range.
Highlight the Actions tab, and the Motion Detection Actions setup screen appears.
Select ─ Activates highlighted blocks to detect motion.
Clear ─ Deactivates highlighted blocks so that they will not detect motion.
Reverse ─ Activates inactive highlighted blocks and deactivates active highlighted blocks.
Select All
─ Activates all blocks to detect motion.
Clear All ─ Deactivates all blocks so that they will not detect motion.
Reverse All ─ Activates inactive blocks and deactivates active blocks.
OK ─ Accepts changes and closes Zone setup.
Cancel
─ Exits Zone setup without saving changes.
You can adjust the minimum number of detection blocks that must
be activated to trigger a motion alarm. Highlighting the box under
the
Min. Blocks heading and pressing the button allows you to
adjust the minimum number of detection blocks for Daytime and
Nighttime independently. Smaller numbers provide greater sensitivity
because fewer detection blocks must be activated.
Highlight the box beside Daytime and press the button. Use the
Up and Down arrow buttons to set the Daytime range. The DVR will
consider the remaining time range as the Nighttime.
Figure 35 ─ Motion Detection Actions setup screen
The DVR can be set to react to motion detection
differently for each camera. Each camera can
be associated with another camera, and/or notify
a number of different devices.
NOTE: You can associate multiple cameras
with a camera that detects motion.
Highlight the box under the Record heading and
press the button. A list of cameras appears.
You can associate as many cameras with that
camera as you wish. If the DVR detects motion
on the selected camera, it starts recording video
from all the associated cameras.