Enelion Wallbox Adspace, Инструкция по сборке

Страница: 10 / 22

Wallbox Adspace - Assembly manual 8 - 2021
4. Assembly
o
WARNING
Before commencing the installation, switch off
the power supplied to the cables.
4.1. Preparing the installation
1. Place the packaged Enelion Wallbox Adspace
horizontally, in accordance with the markings on
the packaging.
Cut the package open along
the indicated line. Take the device out of the
cardboard box, remove the polystyrene protective
casing and put the device in the safe horizontal
position.
2. The polystyrene protection contains useful ac-
cessories necessary for the mounting of the de-
vice.
Before recycling the packaging, collect
those accessories that include:
• 3 mm Allen key,
• cable gland plug,
• RFID configuration card.
3. Open Enelion Wallbox Adspace in accordance
with the instruction included in section 2.1 Open-
ing and closing Enelion Wallbox Adspace .
4.2. Selection of bolts and anchors
Enelion Wallbox Adspace is mounted on vertical sur-
face using bolts. The device has four mounting open-
ings. Additionally, the device is equipped with holds fa-
cilitating the assembly.
Fig. 11: Mounting holes of Enelion Wallbox Adspace as
seen from the back of the device.
Following the information listed below, choose the
appropriate method of assembly, depending on the
mounting surface:
1. four mounting holes are positioned on the plan of
a rectangle with dimensions of 960 mm x 96 mm
(width x height)
2. mounting holes have a diameter of 5,5 mm,
3. the device weighs between 2,8 kg – 3 kg,
4. mounting must provide stability for the device to
withstand significant forces affecting it when plug-
ging and unplugging the charging cable in the
socket.
o
WARNING
Use all four mounting holes in the process of
installation. Failure to comply with the require-
ment will result in the loss of water and dust re-
sistance of the device, as a default classified as
IP 54. This can lead to damage or failure of
the charger, and consequently to loss of life or
health. The manufacturer is not responsible for
damage and injuries arising from failure to ob-
serve the above recommendations.
4.3. Cable routes
The default power cable entry (A entry) is at the top part
of the device.
It is possible to insert the power cables from the bottom
of the device by moving the gland by oneself. To do
this, remove the plugs at the bottom of the device.
The insertion of communication cables (B entry) is pos-
sible from the bottom of the device. This requires the
removal of the plug and the installation of a gland suit-
able for the type and number of communication cables
to be routed. The opening diameter for the communi-
cation cable gland is 19 mm.
9 Assembly