Enelion Wallbox Adspace, Инструкция по сборке

Страница: 6 / 22

Wallbox Adspace - Assembly manual 8 - 2021
2. General information
Wallbox Adspace is a charging station intended for
electric road passenger vehicles. It is made of an alu-
minum casing, closed at its sides with reinforced poly-
mer material. It includes a charging process control
module, a front panel with an RFID reader, an OLED
screen and LED signaling.
It is distinguished by two available TYPE 2 charg-
ing sockets operating in a 3-phase mode and central
panel with illuminated logo according to the design of
the ordering party (max. illumination surface 70 mm x
440 mm / height x width).
Additional accessories can be installed. The range of
functions of the device can be extended by adding such
accessories as Enelion Bridge, Enelion MID or Enelion
RCM B protection. Some parameters and functions can
be changed by reprogramming the device with the use
of the attached RFID card. Enelion Wallbox Adspace is
available in two colors: black and silver.
Fig. 1: Enelion Wallbox Adspace.
All Enelion charging stations are compatible with the
original Enelion Chain communication protocol, which
enables operation in the local network of chargers. This
makes the Enelion DLB function possible to be acti-
vated providing dynamic load balancing, thus reducing
the number of devices that require an Internet connec-
tion and optimizing the use of power in charging vehi-
cles.
All Enelion devices can be fitted with Enelion Bridge
(an add-on to be purchased separately). It equips the
devices with Smart functions and facilitates their con-
nection to a remote management system (OCPP 1.6
compliant) via the Internet.
Ÿ
INFO
For more information, see the “User Guide”. It
contains detailed information about the func-
tionality and use of the device.
2.1. Opening and closing Enelion Wallbox
Adspace.
Ÿ
INFO
The 3 mm Allen key – included with the charger
– is needed to open (or close) the Enelion Wall-
box Adspace. No other tool is necessary for this
operation.
Ÿ
INFO
Closing of the device is performed by repeating
the steps used for opening but performed in the
reverse order.
Ÿ
INFO
The operations described below are identical for
the device already mounted on the wall. Please
note that the device must be opened at least
once before the installation to allow access to
the mounting holes on its back and to connect
the power cable.
1. Remove the rubber plug from the top hole of the
left and the right side of the device.
Fig. 2: Removal of the plugs.
2. Insert the supplied Allen key into the exposed
hole. The key should be inserted until you feel
resistance, i.e. until it cannot be pushed deeper.
5 General information