Enelion Wallbox Adspace, Инструкция по сборке

Страница: 7 / 22

Wallbox Adspace - Assembly manual 8 - 2021
Fig. 3: Inserting an Allen key.
3. Turn the key counterclockwise until the locking
pin is aligned with the side of the charger. Re-
move the Allen key from the hole. Repeat the
actions with the second locking pin on the other
side.
Fig. 4: Unscrewing the locking pin.
4. Slide the front panel upwards of the device by
holding the socket housing – use a suction cup
as an option – until the lower edge of the front
panel is exposed.
Fig. 5: Front panel moved upwards.
5. Holding the socket housing, pull the bottom edge
of the panel until it is released from the housing
and tilted slightly.
Fig. 6: Front panel slightly tilted.
6. Holding the front panel in the same plane, slide it
downwards from the top groove of the device.
Fig. 7: Removing the front panel from the device
housing.
7. Slowly continue to pull out the front panel, aware
of the socket lock that could hook onto the hous-
ing.
Fig. 8: Pulling out the front panel.
8. The front panel may freely rest next to the hous-
ing, hanging within the reach of the socket con-
nection wires.
Fig. 9: The device open with the access to its in-
terior.
Ÿ
INFO
The panel is fitted into place by following the
above operations in the reverse order.
o
WARNING
Be careful not to crimple the signal tape while
fitting the front panel.
6 General information