1 Safety instructions
TopCal S CPC 300
6
EHauser
1.2
Designated use
TopCal S CPC 300 is a fully automatic measuring, cleaning and calibration system for
pH and redox measurements. TopCal S CPC 300 consists of the following components:
•
Transmitter Mycom S CPM 153
•
Control unit CPG 300
•
Multihose with assembly hose clip
•
Bottles for calibration fluid,
•
Communications/Power supply cableCPG 300 / Mycom S CPM 153,
•
Hoses CPG 300 for bottles
The system is supplied complete with power supply cables and bottle hoses.In the non-
Ex version, the CPG 300 and the CPM 153 are connected directly to the power supply.
The Ex version of the TopCal S CPC 300 allows operation even in explosive atmos-
pheres. In the Ex version, the CPG 300 is powered via the communication/power supply
cable from the Mycom S CPM 153 (see XA 236C/07/en).
The manufacturer is not liable for damage caused by improper use or use other than
that for which it is intended.
1.3
Installation, commissioning, operation
Note the following points:
•
If the system is used improperly or other than for its designated use, it may pose a
hazard, e.g. due to improper connection.
•
Installation, electrical connection, commissioning, operation and maintenance of the
measuring system must therefore be carried out exclusively by trained specialists
authorised by the system operator.
•
Technical personnel must have read and understood these operating instructions and
must adhere to them.
•
Always follow the regulations in your country pertaining to the opening
and repairing of electrical instruments.
1.4
Operational safety
#
Warning!
If the device is used for any application other than those described in these Operating
Instructions, it may lead to unsafe and improper functioning of the measuring system
and is therefore not permitted.
The instruments have been designed and tested according to the state of the art and
left the factory in perfect functioning order. The instruments meet all the prevailing reg-
ulations and EC directives - see "Technical data".
However, always pay attention to the following points:
•
Measuring systems used in Ex areas have a separate document (XA 236C/07/a3)
which forms a
component part
of these Operating Instructions. Always follow the
installation regulations and the - partly deviating - connection data in the Ex
documentation as well. You can find the following symbols on the front page of the
additional Ex documentation (according to approval and test centre
(
0
Europe,
2
USA,
1
Canada).
•
The measuring device complies with the general safety requirements in accordance
with EN 61010, the EMC requirements of EN 61326, and NAMUR Recommendation
NE 21, 1998.
•
The manufacturer reserves the right to change the technical data in line with technical
progress at any time. You can obtain information on the current version of this
Operating Instructions and possible additions from your E+H sales centre.
Содержание TopCal S CPC 300
Страница 4: ...TopCal S CPC 300 4 Endress Hauser...
Страница 147: ...TopCal S CPC 300 11 Appendix Endress Hauser 147...
