Commissioning
Smartec S CLD134
10
Hauser
!
Note!
You must perform an air set before installing the sensor. To do so, refer to the chapter
"Calibration".
4.4
Calibration
To access the "Calibration" function group, press the CAL key (code = 22).
Code
Field
Selection or range
Display
Info
C
Function group
CALIBRATION
CALIBRAT
Calibration settings
C1(1)
Compensation of
residual coupling
Airs=Airset (1)
Cellc=cell constant (2)
InstF=Installation factor(3)
AirS
Calibrat
When commissioning inductive sensors,
an airset is mandatory.
The calibration of the sensor is to be
performed in air. The sensor must be dry.
Remove sensor from the medium and dry
completely
.
C111
Residual coupling
start calibration
(airset)
current measured value
0.0
μ
S/cm
AirSet
Start calibration with CAL.
C112
Residual coupling is
displayed
-80.0 ... 80.0
μ
S/cm
5.3
μ
S/cm
AirSetVal
Residual coupling of measuring system
(sensor and transmitter).
C113
Calibration status is
displayed
o.k.
E xxx
o.k.
Status
If the calibration status is not o.k., the
second display line shows an explanation
of the error.
C114
Store calibration
results
yes
no
new
yes
Store
If C113 = E xxx, then only no or
new
.
If new, return to C.
If yes/no, return to “Measurement”.
C1(2)
Calibration of cell
constant
Airs=Airset (1)
Cellc=cell constant (2)
InstF=installation factor(3)
Cellc
Calibrat
Immerse sensor in calibration solution.
!
Note!
This section decribes the calibration for temperature compensated
conductivity. For calibration with uncompensated conductivity, set the
temperature coefficient
α
to 0.
The sensor should be immersed at a
sufficient distance from the vessel wall
(installation factor has no influence if
a > 15 mm / 0.59").
C121
Enter process
temperature (MTC)
25 °C
-35.0 ... 250.0 °C
25.0 °C
ProcTemp.
Only exists if B1 = fixed
C122
Enter
α
value of
calibration solution
2.10 %K
0.00 ... 20.00 %K
2.10 %K
alpha val
This value is specified in the Technical
Information of all E+H calibration
solutions. You can also use the printed-on
table to calculate the value.
Set
α
to 0 for calibration with
uncompensated values.
C123
Enter correct
conductivity value of
calibration solution
current measured value
0.0 ... 9999 mS/cm
10.30 mS/cm
Real. val
The display is always in mS/cm.
