Endress+Hauser Proline Promass 80E, Техническая информация

Страница: 45 / 50

Proline Promass 80E, 83E
Hauser 45
Certificates and approvals
CE mark The measuring system is in conformity with the statutory requirements of the EC Directives.
Hauser confirms successful testing of the device by affixing to it the CE mark.
C-Tick symbol The measuring system complies with the EMC requirements of the "Australian Communications and
Media Authority (ACMA)"
Ex approval Information about currently available Ex versions (ATEX, FM, CSA, IECEx, NEPSI etc.) can be supplied
by your Hauser Sales Center on request. All information relevant to explosion protection is
available in separate Ex documents that you can order as necessary.
Hygienic compatibility 3A approval
Functional safety SIL -2: accordance IEC 61508/IEC 61511-1 (FDIS)
"4–20 mA" - output according to the following options in the order characteristic for "Input/Output":
Promass 80:
A, D, S, T, 8
Promass 83:
A, B, C, D, E, L, M, R, S, T, U, W, 0, 2, 3, 4, 5, 6
See also "Terminal assignment"

ä
9
FOUNDATION Fieldbus
certification
The flow device has successfully passed all the test procedures carried out and is certified and
registered by the Fieldbus Foundation. The device thus meets all the requirements of the following
specifications:
• Certified to FOUNDATION Fieldbus Specification
• The device meets all the specifications of the FOUNDATION Fieldbus H1.
• Interoperability Test Kit (ITK), revision status 5.01 (device certification number: on request)
• The device can also be operated with certified devices of other manufacturers
• Physical Layer Conformance Test of the Fieldbus Foundation
PROFIBUS DP/PA
certification
The flow device has successfully passed all the test procedures carried out and is certified and
registered by the PNO (PROFIBUS User Organization). The device thus meets all the requirements of
the following specifications:
• Certified in accordance with PROFIBUS Profile Version 3.0 (device certification number: available on
request)
• The device can also be operated with certified devices of other manufacturers (interoperability)
Modbus RS485 certification The measuring device meets all the requirements of the Modbus RS485/TCP conformity test and has
the "Modbus RS485/TCP Conformance Test Policy, Version 2.0". The measuring device has successfully
passed all the test procedures carried out and is certified by the "Modbus RS485/TCP Conformance Test
Laboratory" of the University of Michigan.
Pressure Equipment Directive The measuring devices can be ordered with or without PED (Pressure Equipment Directive). If a device
with PED is required, this must be ordered explicitly. For devices with nominal diameters less than or
equal to DN 25 (1"), this is neither possible nor necessary.
• With the identification PED/G1/III on the sensor nameplate, Hauser confirms conformity
with the "Basic safety requirements" of Appendix I of the Pressure Equipment Directive 97/23/EC.
• Devices with this identification (with PED) are suitable for the following types of fluid:
- Fluids of Group 1 and 2 with a steam pressure greater than, or smaller and equal to 0.5 bar (7.3 psi)
- Unstable gases
• Devices without this identification (without PED) are designed and manufactured according to good
engineering practice. They correspond to the requirements of Art. 3, Section 3 of the Pressure
Equipment Directive 97/23/EC. Their application is illustrated in Diagrams 6 to 9 in Appendix II of
the Pressure Equipment Directive 97/23/EC.
Other standards and
guidelines
• EN 60529
Degrees of protection by housing (IP code)