Endress+Hauser Proline Promag H 200, Краткое руководство по эксплуатации

Страница: 6 / 48

Basic safety instructions Proline Promag H 200
6 Hauser
!
WARNING
Danger of breakage of the sensor due to corrosive or abrasive fluids!
►
Verify the compatibility of the process fluid with the sensor material.
►
Ensure the resistance of all fluid-wetted materials in the process.
►
Observe the specified maximum process pressure.
Verification for borderline cases:
►
For special fluids and fluids for cleaning, Hauser is glad to provide assistance in
verifying the corrosion resistance of fluid-wetted materials, but does not accept any warranty
or liability as minute changes in the temperature, concentration or level of contamination in
the process can alter the corrosion resistance properties.
Residual risks
The external surface temperature of the housing can increase by max. 10 K due to the power
consumption of the electronic components. Hot process fluids passing through the measuring
device will further increase the surface temperature of the housing. The surface of the sensor,
in particular, can reach temperatures which are close to the fluid temperature.
Possible burn hazard due to fluid temperatures!
►
For elevated fluid temperature, ensure protection against contact to prevent burns.
2.3 Workplace safety
For work on and with the device:
►
Wear the required personal protective equipment according to federal/national regulations.
For welding work on the piping:
►
Do not ground the welding unit via the measuring device.
2.4 Operational safety
Risk of injury.
►
Operate the device in proper technical condition and fail-safe condition only.
►
The operator is responsible for interference-free operation of the device.
2.5 Product safety
This measuring device is designed in accordance with good engineering practice to meet state-
of-the-art safety requirements, has been tested, and left the factory in a condition in which they
are safe to operate.
It meets general safety standards and legal requirements. It also complies with the EC directives
listed in the device-specific EC Declaration of Conformity. Hauser confirms this by
affixing the CE mark to the device.