FieldPort SWA50
Configuration and online parameterization
Hauser
65
Parameter
Description
Standardized Status 1
Selection
• Status simulation active
• Discrete variable simulation active
• Event notification overflow
• Battery or power needs maintenance
Standardized Status 2
Selection
• Device was added or disconnected from the wired interface.
• Adapter discovered another master of same type.
• Sub device mismatch
• Sub devices with duplicated IDs found
• Stale data notice
Standardized Status 3
Selection
• Adapter was unable to get required bandwidth.
• Adapter asked for bandwidth and is awaiting a response.
• Block transfer pending
• Radio failure
Description of parameters for "Event Notification", "Device-Specific Event Mask" tab
Monitoring of device-specific events
• HART field device: see the Operating Instructions for the connected HART field
device
• FieldPort SWA50: see the following table
Monitoring of standard events for FieldPort SWA50
Byte
Bit
Description
0
0
No join attempt started so far.
1
Adapter is not connected to a wireless network.
2
No alternative path to a neighbor.
3
Adapter has no join key.
4
Adapter could not join the wireless network.
5
WirelessHART started.
6
Bluetooth connection active.
7
–
1
0
Adapter cannot communicate with the field device.
1
HART modem failure
2
–
3
–
4
–
5
Adapter is in configuration mode.
6
Adapter is searching for connected devices.
7
–
2
0
Adapter hardware is defective.
1
Adapter is executing a self-test.
2
Adapter temperature out of specified range.
3
–
4
Number of write cycles to FLASH at critical level.
5
Number of write cycles of FLASH at maximum level.
6
–
7
–
Содержание FieldPort SWA50
Страница 16: ...Installation FieldPort SWA50 16 Endress Hauser 5 A0040502 6 A0040501 ...
Страница 23: ...FieldPort SWA50 Installation Endress Hauser 23 6 A0041513 7 A0040503 8 A0040501 ...
Страница 75: ......
Страница 76: ...www addresses endress com 71519085 71519085 ...