Endress+Hauser FieldPort SWA50, Руководство по эксплуатации

Страница: 36 / 76

Commissioning FieldPort SWA50
36 Hauser
8 Commissioning
8.1 Requirements
8.1.1 Requirements of the FieldPort SWA50
• The FieldPort SWA50 is electrically connected.
• DIP switch 1 for Bluetooth communication must be set to ON →  43.
8.1.2 Information required for commissioning
You will need the following information for commissioning:
• HART device address of HART field device
• Device tag of HART field device
• Long tag for HART-6 and HART-7 field devices
• Short tag for HART-5 field devices
• Device tag of HART field device in WirelessHART network
• Long tag for HART-6 and HART-7 field devices
• Device tag for HART-5 field devices
Each device tag in the WirelessHART network must be unique.
You must check the following before commissioning:
• Is there another HART master in the HART loop of the FieldPort SWA50?
If yes, is it a primary or secondary HART master?
• Is there a HART communication resistor ≥ 250 Ohm outside of the FieldPort SWA50 in
the 4 to 20 mA loop?
If yes, is the HART communication resistor connected in series between the "IN+"
terminal of the FieldPort SWA50 and the supply voltage, e.g. PLC or active barrier?
In addition to the FieldPort SWA50, only one other HART master is permitted in the
HART loop. This other HART master and the FieldPort SWA50 must not be of the
same master type.
8.1.3 Initial password
The initial password can be found on the nameplate.
8.2 Putting the FieldPort SWA50 into operation
The FieldPort SWA50 can be operated as follows via Bluetooth:
• Via smartphone or tablet with the Hauser SmartBlue App
• Via Hauser Field Xpert SMTxx tablet PC
In addition, the WirelessHART version of the FieldPort SWA50 can be operated via
FieldCare SFE500.
Operating Instructions for FieldPort SWA50 WirelessHART: BA02046S