qTOWER³ / qTOWER³ G
Maintenance and care
29
}
Note the code on the color module and the position in which the color
module is to be installed. Remove the old color module or dummy ele-
ment (dummy module). To do this, unscrew the two M2 screws and pull
the color module out.
Keep the color module or dummy element.
}
Place the new color module in the free position with the pin pointing
down. The silver pin points to the motor axis and must engage in the
centering hole next to the large hole for the pin of the color module.
NOTICE! The correct position of the color module can be found more
quickly if you rotate the color module slightly around its own axis during in-
sertion.
}
Press the color module down until it rests flat on the filter wheel.
}
Screw on the color module with the M2 screws supplied.
}
Repeat this procedure for all color modules.
}
Close the remaining openings of the filter wheel with the color module
dummy elements supplied to protect them from light.
}
Rotate the filter wheel with the installed color modules and check
whether the color modules grind against the upper lid.
If this is the case, loosen the screw connection of the color module. Check
its position again and retighten the screws.
NOTICE! Do not attempt to force a jammed color module into the correct
position simply by tightening it further. The sensitive optics may become
damaged.
}
Push the hood back in its initial position.
}
First fasten the four external screws on the upper part on the rear of the
device.
}
Open the lid and fasten the four outer screws on the inside of the lid.
}
Close the lid again.
ü
The color modules are installed.