Endace DAG 4.2S, Руководство пользователя

Страница: 10 / 39

EDM01-02: DAG 4.2S Card User Guide
©2005 5 Version 7: May 2006
Chapter 2: Installation
Introduction
A DAG 4.2S card can be installed in any free 3.3v signalling 64-bit Bus
Mastering PCI slot. The DAG 4.2S card is capable of running at 66MHz,
but if any other device on the same bus is not capable of 66MHz operation
then all devices on the bus will operate at 33MHz.
Although by default, the driver supports up to four DAG cards in one
system, there should not be more than two cards on a single PCI bus due to
bandwidth limitations. However, this is not usually a limitation as for most
applications a maximum of two cards only can be used with reasonable
application performance.
In this chapter This chapter covers the following sections of information.
Insta
l
lation of Operating System and Endace Software
Insert the Card into PC
DAG 4.2S Card Optical Connectors
2.1 Installation of Operating System and Endace Software
Description If the DAG device driver is not installed, before proceeding with the next
chapter, install the software on Linux/FreeBSD operating systems by
following the instructions in EDM04-01 Linux/FreeBSD Installation
Guide.
To install the software on a Windows operating system, follow the
instructions in EDM04-02 Windows Installation Guide.
Go to the next section of information when the DAG device driver is
installed.
2.2 Insert the Card into PC
Description Inserting the DAG 4.2S card into a PC involves accessing the bus slot,
fitting the card, and replacing bus slot screw.
Procedure Follow these steps to insert the DAG 4.2S card.
Step 1. Access bus Slot
Power computer down.
Remove PCI bus slot cover.