Endace DAG 3.6D, Руководство пользователя

Страница: 10 / 38

EDM01-14 DAG 3.6D Card User Guide
©2005 5 Version 10: May 2006
2.0 INSTALLING DAG 3.6D CARD
Introduction A DAG 3.6D card can be installed in any free Bus Mastering PCI slot
The DAG 3.6D card should be the only device on the PCI bus if possible
as the cards make very heavy use of PCI bus data transfer resources.
Although the driver supports up to four DAG cards by default in one
system, due to bandwidth limitations there should not be more than one
card on a single PCI bus. However, this is not usually a limitation as for
most applications a maximum of two cards only can be used with
reasonable application performance.
In this section This section covers the following topics of information.
•
Installation of Operating System and Endace Software
•
Insert DAG 3.6D Card into PC
•
DAG 3.6D Card Port Connectors
2.1 Installation of Operating System and Endace Software
Description
If the DAG device driver is not installed, before proceeding with the next
chapter, install the software by following the instructions in EDM04-01
Endace Software Installation Manual.
Go to the next chapter of information when the DAG device driver is
installed.
2.2 Insert DAG 3.6D Card into PC
Description
Inserting the DAG 3.6D card into a PC involves accessing the PCI-X bus
slot, fitting the card, and replacing bus slot cover.
Procedure Follow these steps to insert the DAG 3.6D card.
Step 1. Access bus Slot
Power computer down.
Remove PCI bus slot cover.
Continued on next page