Encore 1102771A, Руководство пользователя по изделию

Страница: 24 / 93

Operation
3-2
Part 1102771A
E
2010 Nordson Corporation
Startup
(contd)
Fluidizing Air
Regulator/Gauge
Spray
Gun
Interface
Controller
Interface
Controller
Power
Switch
On
Off
Standby
Button
Figure 3-1 System Controls
5. Make sure the spray gun is not triggered, then turn on controller power.
The displays and icons on the controller interface and gun interface will
light.
6. The fluidizing air turns on when the interface is turned on. Adjust the
fluidizing air pressure to 0.3--0.7 bar (5--15 psi). The pressure should be
just enough so the powder in the hopper “boils” gently. Fluidize the
powder for 5--10 minutes before spraying powder.
7. Point the spray gun into the booth and press the trigger to start spraying
powder.
NOTE: If using Total Flow mode, the total air setpoint must be greater than
zero or you will not be able to set % Flow Air and the gun will not spray
powder. Refer to page 3-13 for more information.
8. Select the desired preset and start production.
The controller interface displays actual output when the gun is spraying and
the current preset setpoints when the gun is off.
Factory Set Presets
Presets are recipes with electrostatic and powder flow setpoints for a
particular part or application. 20 presets are available. Presets 1--3 are
setup for you. Refer to Preset Setup on page 3-10 for preset setting
instructions.
P El i O d P d Fl
Setpoints
Preset Electrostatic Output and Powder Flow
kV

A %

1 Max kV, 150 g/min (20 lb/hr) 100 30 45 3.0
2 Max kV, 300 g/min (40 lb/hr) 100 30 75 3.0
3 Select Charge 3 (deep recess), 150 g/min (20 lb/hr) 100* 60* 45 3.0
* Select Charge Mode settings are factory set and cannot be changed.