Enatel DC System Manual
Page
10
of
26
Model: RWxxx
Version: 3.6
When rectifiers are connected in parallel using an RJ45 cable to connect between the
alarm and control interface on each rectifier, the alarm outputs on the Alarm Card give
the status of all the connected units. This means that only one alarm card needs to be
connected to the alarm circuitry when the rectifiers are connected in parallel
3
I
NSTALLATION
3.1
General Warnings
This rectifier contains no user serviceable components. Do not disassemble the rectifier.
To isolate the rectifier from the mains power, unplug the IEC mains connector from the
rectifier.
DANGER
Do not operate the rectifier if the covers are damaged
or removed in any way.
WARNING The rectifier contains voltages that may be lethal even
after the input supply has been removed.
WARNING The rectifier contains components at high temperature
that may burn if touched
3.2
Rectifier Positioning
Caution
The rectifier is convection cooled and MUST be mounted correctly.
It must be on a vertical surface (wall), perpendicular to the floor.
It must be mounted in a “landscape” orientation with side
connectors on the right.
Do not mount rectifiers above each other.
Observe all instructions on the rectifier.
