emmeti EH0618DC, Инструкция по установке и эксплуатации

Страница: 86 / 108

86
1. DESCRIZIONE DEI COMPONENTI
GB GB
7. LIST OF PARAMETERS "SMART MT" 7. LIST OF PARAMETERS "SMART MT"
Menù
label
Par Label Description U.m.
Range
Default
C-TH PW
Address
(Base 0)
min max
EHS
137 
How to activate heat generators:
0: Additional generator disabled
1: When the additional generator is activated, the heat pump switches
off.
2: When the supplementary generator is activated, the heat pump re-
mains on.
- 0 2 0 S 16408
138

Bivalence set point (additional generator):
Outdoor temperature at which the free contact "Ext. Heat Source ”
can be activated (clamps F-L)
°C -15.0 10.0 5.0 S 16409
139 
Bivalence delay (additional generator):
On-going time, in which the outdoor temperature is below than the
bivalence set point, until the free contact “Ext. Heat Source ” activates
(clamps F-L)
h:
min
00:01 02:00 00:30 S 16410
PUMP 140  Factory parameter, do not change - - - 0 S 16487
AL

Room temperature probe fault CRONO-TH 9007
 Ambient humidity probe fault CRONO-TH 9008

Outdoor temperature probe fault 9003
 Outlet water temperature probe fault 9005

Error signal “Temp. Water Supply System” (clamps 3-4) 9004
 Sanitary storage temperature probe fault 9006

Heat pump error. Error code on PCB display 9010
 Remote controller connection error 9009

Condensation risk for the radiant cooling system 9012
 Overheating risk for the radiant heating system 9013