1.Introduction
1.1 General Specifications
4
1.2 Warranty
EMKO Elektronik warrants that the equipment delivered is free from defects in material and
workmanship. This warranty is provided for a period of two years. The warranty period starts from
the delivery date. This warranty is in force if duty and responsibilities which are determined in
warranty document and instruction manual performs by the customer completely.
1.3 Maintenance
Repairs should only be performed by trained and specialized personnel. Cut power to the device
before accessing internal parts.
Do not clean the case with hydrocarbon-based solvents (Petrol, Trichlorethylene etc.). Use of
these solvents can reduce the mechanical reliability of the device. Use a cloth dampened in ethyl
alcohol or water to clean the external plastic case.
The unit provides the voltage monitoring for both sources and automatic transfer switching. In
the event of any Source voltage failure, the remote start relay output is energized(
) and the unit automatically transfers the load from one source to other.
if generator
application selected
If a fault is detected, the unit shuts down the engine(if generator application selected), transfers
load to the other source and shows the failure message on the LCD display.
Both automatic and manual control is possible. A test mode is also available which allows the
generator with the higher priority to be run.
The unit is extensively programmable through the front panel, with password protection on
two levels. Operational parameters can also be monitored and controlled from a PC via a
built-in USB port.
The unit monitors both sources and gives warning of any faults that are detected.
Trans-ATS.D:
Trans-ATS.D.RS485:
Automatic transfer switch with USB communication
Automatic transfer switch with USB and RS-485 communication
1.4 Order Information