E-mail: [email protected]
Made in Rome, New York, USA
14
START-UP, MAINTENANCE AND TROUBLESHOOTING PROCEDURE
The Test Unit Performance Data sheet below is provided
for use by a qualified service professional. In order for our
Technical Service Department to better serve you, please
complete and have this information ready when calling.
Make sure to include the Model Number, Serial Number,
Date of Installation.
Call our Technical Support Department
@ 1-800-228-9364.
Test Unit Performance Data
Date:
Model Number
Technician:
Serial Number
Mode:
Cooling
Indoor Section
Notes
Evaporator Entering Air - DB
NOTE:
Rotary compressors are critically charged sys-
tems, do not over charge. Refer to the Charge Table
specific to you unit (SCC /SHC pg. 8, MC4/MH4 pg. 9,
MC2/MH2 pg. 11) or call the factory. Anti-short cycle
protection should be used on systems that use a con-
ventional thermostat.
Evaporator Entering Air - WB
Evaporator Leaving Air - DB
Evaporator Leaving Air - WB
Outdoor Section
Entering Air
Leaving Air
Temperature Split
Operating Pressures
Compressor Suction - PSIG
Compressor Discharge - PSIG
Power Input
Compressor - Volts
Compressor - Amps
OD Fan Motor - Volts
OD Fan Motor - Amps
ID Fan Motor - Volts
ID Fan Motor - Amps
Total Volts
Total Amps
Temperatures - Degrees F°
Compressor Suction
Compressor Discharge
Liquid Out Cond.
Liquid before Expansion
Suction out Evaporator
Capacity Calculations
DB - Temp Split at evap.
Test Summary
Compressor Superheat
Sub Cooling
Save this information for future servicing.
In the event there is a problem with the unit.
Perform the test again (if possible) and have both sets of data
ready when calling for assistance.
