10
E-mail: [email protected]
Made in Rome, New York, USA
DESCRIPTION
The FHP 09-30 and 36-48 is available in two cabinet
sizes with nine capacities in Cooling Only or Heat Pump
(depending on condenser match).
FHP units are equipped with a universal control board
that allows the unit to operate in either straight cool or heat
pump mode. The unit is configured by changing dip switch
settings prior to installation.
FHP units are shipped from the factory set in cooling
only mode and will need to be reset for heat pump applica-
tions.
The FCP is a Chilled Water model with electric or hot
water heating options and is compatible with any chilled
water source of matching capacity.
The FHP/FCP operates with very low sound levels and
is available with several options. It is compatible with any
EMI outdoor unit. The FCP is matched with a remote chilled
water source, not supplied by EMI.
A unit mounted, electronic, digital control is standard
and an optional infrared handheld remote control is avail-
able. Fresh air knockouts and anti-short cycle protection
are standard features on all FHP units and additional op-
tions include supplemental electric or hydronic heat. Op-
eration from a wall thermostat is an available option.
NOTE: Hydronic heat is available only in non-heat
pump applications.
SYSTEM OPTIONS
• ETL approved 3-7kw electric heat with safety con-
trols
• Condensate pump, (factory installed)
• Fan-induced fresh air
• Single-stage hydronic heat with sweat connections
(not available in heat pump applications; must be
factory installed)
NOTE: The FHP utilizes a molded plastic top. DO
NOT sit or stand on it as you may damage the unit.
1. Check equipment for damage before mounting.
2. Determine the best location for mounting the unit for
optimum air circulation.
3. Locate the indoor and outdoor units as close together
as possible (See outdoor unit requirements.)
NOTE: FHP 42 contains Kit# 550-121 that includes a
.073" I.D. orifice. The existing factory installed .078"
orifice must be replaced when matching the Air Han-
dler with a 36,000 Btuh Condensing Unit. (See the
instructions attached to Kit# 550-121 for proper con-
version procedure.)
4. Determine the following:
• Power supply wire routing
• Interconnect refrigerant piping routing
• Chilled water and condensate piping routing (FCP)
• Low voltage control interconnect wiring
• Fresh air ducting (if required)
NOTE: The large refrigerant line (suction) must be
insulated. Allow extra clearance in any opening
for this line.
5. If the unit has a field supplied fresh air wall box, make
certain that the bottom of the opening is level with
the top of the finished floor and ensure that the wall
box is pitched slightly toward the outside.
6. Tubing may be run through the knockouts located on
the bottom left rear (room side) of the unit, as well
through knockouts in the back of the unit.
7. Maximum allowable length and lift of interconnect
refrigerant lines can be found in either the instruc-
tions for the accompanying outdoor unit or EMI Bul-
letin #01012 Rev 1: Tubing Run Length Recommen-
dations (to obtain a copy consult your sales rep or
distributer.)
8. Consider future servicing of the unit when determin-
ing mounting location. All FHP service is performed
by removing the front (room side) panels.
FLOOR MODEL AIR HANDLER
(FCP/FHP)
