Emerson Rosemount CT5100, Справочное руководство

Страница: 85 / 179

8 Operating the analyzer
8.1 Introduction
This section describes the normal operation of the analyzer.
NOTICE
The gas concentrations shown in the following screenshots may be different from those
shown in your particular analyzer. The screenshots indicate the functionality of the
software, which is the same regardless of the gases or gas concentrations being measured.
WARNING
BURN HAZARD
Some parts of the analyzer may be heated to 320 °F (160 °C). To prevent burns, do not
touch any of the hot parts. All components of the analyzer are hot unless it has been
switched off and allowed to cool down.
Before fitting, removing, or performing any maintenance on the analyzer, ensure that it
has been switched off and allowed to cool for at least two hours. Before performing any
maintenance on or in the vicinity of the analysis cell, allow the analyzer to cool for at least
twelve hours, as the analysis cell is insulated against heat loss.
When handling the analyzer, always use suitable protective gloves.
Personal injury and/or damage to property may result if these safety precautions are not
observed. These precautions are especially important when working at heights. If you
receive a burn, seek medical treatment immediately.
8.2 Normal operation
The analyzer is designed for long term continuous operation, and therefore its normal
state is to be switched on and performing gas measurements. The analyzer is usually only
switched off for maintenance.
During normal operation, either the Gas Sensor Main screen ( Figure 8-1 ) or the Pressure and
Temperature screen ( Figure 8-2 ) is shown on the display controller. To toggle between
these two screens, press PAGE .
Reference Manual Operating the analyzer
00809-0100-4512 October 2019
Reference Manual 85