Emco compact 8, Инструкция / Перечень запасных частей

Страница: 22 / 57

Top slide spindle
Remove the 2 screws holding the spindle bracket in
position and unscrew the spindle. Adjust the screwed
ring (1) until all backlash has been eliminated.
Adjustment of half-nut guide
Loosen the two screws ( 1) on the right hand side of
the apron and adjust the control screw (2) until both
half-nuts move freely without play. Tighten both screws
again.
Adjustment of leadscrew liacklash
Loosen the grub screw No. 1 which is on the underside
of the apron until - with the half-nuts engaging the lead
screw-backlash is eliminated.
Replacing the shear pin in the leadscrew
If the s·hear pin breaks due to overoad or abuse, it
must be replaced.
NOTE!
Make sure that only EMCO shear pins are fit­
ted.
lnorder to knock out the broken pin, the hex headed
screw must be loosened and the pinion removed. Take
off the sleeve and knock the broken pin out of the
sleeve and leadscrew. Replace the sleeve, line up the
holes and fit new pin. Reassemble.
21