Ion generation frequency
1 Hz
3 Hz
5 Hz
10 Hz
15 Hz
20 Hz
30 Hz
60 Hz
Symbol
Cable colour
Description
Connection
DC1 (+)
Brown
Power supply 24 VDC
DC1 (–)
Blue
Power supply GND [FG]
OUT4
Green
Sensor monitor
output
Determining the Model and Settings
5) Frequency selection switch setting
· Selects ion generation frequency
6) Wiring of power supply cable
· Connect the dedicated power supply cable.
Connection with ionizer driving power supply
∗
DC1 (–) [Blue] is sure to groung it
according to class-D. If the
Wiring of
input/output signal power suply
Symbol
Cable colour
Description
Connection
DC2 (+)
Red
Power supply 24 VDC
DC2 (–)
Black
Power supply GND
IN1
Yellow green
Discharge
stop
signal
IN2
Gray
Maintenance start signal
—
White
—
—
Orange
—
OUT1
Pink
Static electricity
removal
completion signal
OUT2
Yellow
Maintenance output signal
OUT3
Purple
Irregular
signal
: Minimum wiring
requirement for ionizer operation
: Wiring
necessary to use various functions
—: Wiring not
required in the sensing DC mode. Exercise caution
7) Air piping
· For single-side piping, block the unused port with
Ionizer
Series
Switch
setting
0
1
2
3
4
5
6
7
Connection needs
Contents
Ionizer driving power supply cable
—
—
Settings 2 / Pulse DC Mode
supply
the terminal is not
grounded, the ionizer may malfunction.
cable
Connection needs
Contents
Input/output signal power supply cable
Signal for
enabling/disabling discharging
(NPN specification) Discharging is enabled when connected
(PNP specification) Discharging is enabled when connected
Signal to be input when
determining the necessity of electrode
—
—
—
—
Signal to be output when the workpiece’s
electrostatic potentia
when
electrode needle contamination is being detected.
Signal to be output when electrode needle maintenance
Outputs signal when there is irregular high voltage, irregular sensor, irregular
caution to
ensure that this wire does not short-circuit to other wires.
with the M-5P plug supplied with the ionizer.
Series
IZS31
DC power supply
Brown
Blue
+24 VDC
GND
Class-D ground
connected to DC2 (–) [Black].
connected to DC2 (+) [Red].
electrode needle maintenance
electrostatic potential is outside
±
30 V or
is necessary.
irregular CPU (B type contact output)