EMC IZS31 Series, Руководство пользователя

Страница: 18 / 39

Series
IZS31
Determining the Model and Settings
1. Sensing DC mode
(Refer to page 14 when using
1) Selection of bar length
· Select the appropriate length suited for a work
Removal Range”, etc.
2) Installation of the ionizer
· Install within 200 to 2000 mm. Although the main
on the conditions of use. Before use, always verify
3) Installation of the sensor
· Install the feedback sensor with the detection hole
· Installation at a height from 10 to 50 mm is recommended.
operate normally depending on the conditions of
(Refer to “Installation height of feedback sensor
· When the ionizer and feedback sensor are connected,
4) Configuration of dirt-detection level on an electrode
· Maintenance level selection switch
· Set the switch to either H (high), M (middle) or
dirt-detection.
H (High) Level that does not
M (Middle) Level immediately
L (Low) Level at which the
Note) Dirt-detection starts when the maintenance start signal is input.
5) Configuration of frequency selection switch
· Use this switch to select “Energy Saving Mode”
· This switch is used to select ion generation frequency
electricity removal.
Energy saving
mode
Automatically
electricity
completing
removal.
Continuous
static electricity
Continously
electricity
controlling
that the
workpiece
removal mode
V even
static electricity
The ionizer
the
preset
Settings 1 / Sensing DC Mode
using the ionizer in the pulse DC mode, or refer to page 18 when
work size by referring to “Static electricity Removal Characteristics”
main unit can also be used at other distances, it may fail to operate
verify that the main unit is functioning normally.
hole facing the charged surface.
recommended. Although the sensor can also be used at other heights,
of use. Before use, always verify that the sensor operates normally.
sensor and discharge time/Ion balance” on page 2 as a guide.)
connected, the sensing DC mode is automatically selected.
electrode needle
L (low). At settings other than these, the ionizer does not perform
not effect the discharge time.
before the discharge time is extended.
discharge time is longer than it was initially.
∗
Settings
input.
Mode” or “Continuous Static Electricity Removal Mode”.
frequency for “Continuous Static Electricity Removal Mode,” after
How to run
Automatically stops emitting
electricity even after
completing the static electricity
removal.
+ ion Stop
– ion
Continously eliminates static
electricity with pulse DC by
controlling the ion balance so
charged potential on a
workpiece would be within ± 30
+ ion
– ion
Pulse operation
after completing the
electricity removal.
ionizer generates ions at
preset frequency.
(Example) Charged object workpiece:
negative electric charge
Static electricity
removal completed
the same level.
when using it in the DC mode.)
Characteristics” and “Static electricity
operate normally depending
heights, it may fail to
normally.
perform electrode needle
Settings with the same letter share
after the completion of static
run Switch setting
operation
0···1 Hz
electricity
completed
1···3 Hz
2···5 Hz
3···10 Hz
4···15 Hz
5···20 Hz
6···30 Hz
7···60 Hz