Series
IZS31
Manual
operation
When
detects
detection
An ion
When
After
adjustment
Automatic
operation
The ionizer
removed,
Determining the Model and Settings
2. Pulse DC
mode
1) Selection of bar length
· Determine the length suited for a work size, referring to
Range”, etc.
2) Installation of the ionizer
· Install the ionizer within 50 to 2000 mm of the
100 to 2000 mm when using an autobalance
operate normally depending on the conditions
3) Installation of the sensor
· When adjusting the ion balance using a sensor,
· Install the sensor immediately below the ionizer
· When an autobalance sensor is connected, the
4) Configuration of maintenance level selection
· This switch is used to select “Manual Operation”
balance.
AUTO MANUAL
∗
Set the switch
according
When an
autobalance sensor is not used.
When an autobalance sensor is not used, set the
adjustment trimmer.
Ion
balance adjustment trimmer
· Configuration of dirt-detection level on an electrode
· Set the switch to either H (high), M (middle) or
dirt-detection
H (High) Level not influential
M (Middle) Level immediately
L (Low) Level at which
· Dirt-detection starts when the maintenance start signal
· When the switch is set to H, M or L, the ionizer
Details of
operation
When a maintenance start signal is input or the ionizer is turned on,
detects electrode needle contamination according to ion balance adjustment and
detection level settings.
An ion balance adjustment value for each ion
generation frequency is
When the ion
generation frequency is changed, adjust the ion balance.
r a
djustment, the autobalance sensor may be removed as io
adjustment will not be performed again until a maintenance start signal is input.
ionizer
continuously adjusts the ion balance. When the autobalance
removed, adjust the ion balance manually using the ion balance adjustment
Settings 2 / Pulse DC Mode
referring to the “Static electricity Removal Characteristics” and “Static
the object requiring electricity removal. However, install the main
autobalance sensor. Although the main unit can also be used at other
of use. Before use, always verify that the main unit is functioning
sensor, install an autobalance sensor.
ionizer so that it is level with the workpiece.
the ion balance adjustment trimmer settings are nullified.
selection switch
Operation” or “Automatic Operation” when an autobalance sensor is connected
according to the dirt-detection level.
used.
the switch to AUTO. Then, adjust the ion balance manually
electrode needle.
L (low). At settings other than these, the ionizer does not perform
influential to the
discharge time
immediately before the discharge time elongates.
the discharge time is longer than it initially was.
start signal is input.
performs electrode needle stain-detection and then adjusts the
Switch
setting
the ionizer
adjustment and
is retained.
on balance
input.
MANUAL
autobalance sensor is
adjustment trimmer.
AUTO
“Static electricity Removal
main unit at a distance from
other distances, it may fail to
functioning normally.
connected to adjust the ion
manually using the ion balance
perform electrode needle
the ion balance.
