80
Appendix
IND100077-179
ATX / AT Power Modes
Battery Connected. ATX mode:
BIOS setting
Battery
Power Status
Expected
Results
Always On
Connected
ON
ON
ON
Always On
Connected
OFF
ON
ON
Last State
Connected
ON
ON
ON
Last State
Connected
OFF
OFF
OFF
Always Off
Connected
ON
OFF
OFF
Always Off
Connected
OFF
OFF
OFF
Battery Disconnected. ATX mode:
BIOS setting
Battery
Power Status
Expected
Results
Notes
Always On
Disconnected
ON
ON
OFF
See note
below for
ATX Mode.
Always On
Disconnected
OFF
ON
OFF
Last State
Disconnected
ON
ON
OFF
Last State
Disconnected
OFF
OFF
OFF
Always Off
Disconnected
ON
OFF
OFF
Always Off
Disconnected
OFF
OFF
OFF
Battery Reconnected. ATX mode:
BIOS setting
Battery
Power Status
Expected
Results
Notes
Always On
Reconnected
ON
ON
OFF first boot, then ON
See note below
for ATX Mode.
Always On
Reconnected
OFF
ON
OFF first boot, then ON
Last State
Reconnected
ON
ON
OFF first boot, then ON
Last State
Reconnected
OFF
OFF
OFF
Always Off
Reconnected
ON
OFF
OFF
Always Off
Reconnected
OFF
OFF
OFF
AT mode:
BIOS setting
Power Status
Expected
Results
Always On
ON
ON
ON
Always On
OFF
ON
ON
Last State
ON
ON
ON
Last State
OFF
ON
ON
Always Off
ON
ON
ON
Always Off
OFF
ON
ON
*Notes:
Due to limitations in Super I/O firmware, the behavior of Last State and Always On power mode settings in BIOS is affected if CMOS
battery is removed or dead.
- If battery is dead or not present, the power button must be used to power on the unit.
- After battery is replaced, the power button must be used to power up the unit the first boot. After that it will return to normal behavior.
- Note that the system will show warning during boot, if battery voltage is below set limit (default: 2,6V, can be changed in BIOS), giving
users time to plan service to replace the battery before the battery dies.
For setups where this limitation is not acceptable, the workaround is to set the system to AT mode. The system will then always start
when power is connected, and the BIOS settings are ignored.
- If this is required, please specify “AT mode” option when ordering new units, as it’s a jumper setting modified during production process
or by authorized service partner.
Содержание HATTELAND HT B30G STC M Series
