EM SRP 15502 DR Basic line, Руководство по эксплуатации

Страница: 9 / 60

7.1 Periodic maintenance
For the pump to function perfectly
at any time periodic maintenance
is required. This also applies if
the pump is used under heavy
conditions, but does not run for
extended periods of time (e.g.
when used in well drains):
Yearly service
1. Check pump casing and
cables for damage.
2. Rinse pump with clear
water. Remove persistant
soiling, e.g. algae desposits,
with brush and dishwashing
liquid.
3. To flush the inside of the
pump, place it into a
container filled with clear
water and switch ON briefly.
7.2 Pump storage
A
Caution!
Frost damages the pump and
accessories, as both always
contain
water!
x
When there is danger of
freezing
remove pump and
accessories and store at a
frost-proof location.
A
Danger!
Prior to all servicing:
Switch Off.
Unplug.
8.1 Fault finding
Pump does not run:
x
No mains voltage.
Check cables, plug, outlet
and mains
use. ̀
x
Mains voltage too low.
Use only extension cables
with sufficient lead cross section
(see "Technical Specifications").
x
Motor overheated, motor
protection................
Remove cause for
overheating
(fluid pumped too
hot? Pump
blocked by foreign
objects?)
After cooling off the pump will
switch ON again.
Motor hums but does not start:
x
Pump blocked by foreign object.
Clean pump.
Pump does not pump properly:
x
Delivery head too high.
Observe max. delivery head
(see "Technical Specifications").
x
Discharge hose kinked.
Straighten discharge hose.
x
Discharge hose leaky.
Seal discharge hose, tighten
screw fittings.
Pump runs very noisily:
x
Pump primes air.
Ensure there is a sufficient
water supply.
Hold pump at an angle
when sub-merging.
A
Danger!
Repairs to electric tools must only
be carried out by a qualified
electrician!
Electric tools in need of repair can
be sent to an authorised service
center in your country. See spare
parts list for address. Please attach
a description of the fault to the
electric tool.
The packaging of the pump can
be 100 % recycled.
Worn out power tools and
accessories contain considerable
amounts of valua-ble raw and
plastic materials, which can be
recycled.
These instructions are printed on
chlo-rine-free bleached paper.
For this equipment the following
acces-sories are available at
specialist dealers.
3
Note:
Illustrations and stock numbers
can be found at the end of
A
Multi adaptor
Inlet port thread:
1" male
Discharge port thread: 1" male + 3/4"
male + hose stem 1" + 3/4"
B
Elbow Inlet port thread:
1" female
Discharge port thread: 1" IG + 1 1/4"
AG
C
Discharge hose for
submersible pumps 1" x 7m
(AG=male, IG=female)
8. Trouble Shooting
9. Repairs
10. Environmental Protection
11. Available Accessories
EN
A
Danger!
Prior to all servicing:
Switch Off.
Unplug.
Service and repair work
other than
described here must
be left to quali-fied specialists.
7. Care and Maintenance
SPR 15502 DR
5
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com