Elvox 46241.F16H, Инструкция по установке и эксплуатации

Страница: 88 / 124

86
EN
7.1.2 Advanced Configuration
Click Start

Settings

Record

Advanced to go to the following interface. Enable or disable cycle record (cycle record: the earliest record data will be
replaced by the latest when the disks are full). Set the pre-alarm record time, post-alarm record time and expiration time of each camera and then click “Apply”
to save the settings.
Pre-alarm Record Time : set the time to record before the actual recording begins.
Post-alarm Record Time : set the time to record after the actual recording is finished.
Expiration Time : set the expiration time for recorded video. If the set date is overdue, the recorded data will be deleted automatically.
7.2 Encode Parameters Setting
Click Start

Settings

Record

Encode Parameters to go to the interface as shown below. Set the video encode, resolution, FPS, bitrate and audio of main
stream for each camera in “Event Record Stream” and “Timing Record Stream” interfaces. Click “Apply” to save the settings. You can set the record stream
of each camera one by one or batch set them for all cameras.
Click Start

Settings

Record

Stream Settings to go to “Sub-stream” interface. Set the video encode, resolution, FPS and bitrate of sub-stream for each
camera in the interface and then click “Apply” to save the settings.