97
EN
9 Alarm Management
9.1 Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of each camera and then set up the alarm handling of each camera.
1- Click Start
Settings
Alarm
Sensor Alarm to go to the following interface.
2- Select the alarm type (NO or NC) according to trigger type of the sensor.
3- Enable the sensor alarm of each camera.
4- Check the “Record”, “Snap”, “Alarm-out” and “Preset” and enable or disable the “Buzzer”, “Pop-up Video”, “Pop-up Message Box” and “E-mail” as
required.
5- Click “Apply” to save the settings.
The configuration steps of the above mentioned alarm linkages are as follows.
Record
: check it and then the “Trigger Record” window will pop up automatically (you can also click “Configure” button to pop up the window). Select camera
on the left side and then click
to set the camera as the trigger camera. Select trigger camera on the right side and then click
to cancel the trigger
camera. Click “OK” button to save the settings. The trigger cameras will record automatically when the sensor alarm is triggered.
Snap
: check it and then the “Trigger Snapshot” window will pop up automatically. Configure the trigger camera in the window. The trigger cameras will snap
automatically when the sensor alarm is triggered.
Alarm-out
: check it and then the “Trigger Alarm-out” window will pop up automatically. Configure the trigger alarm-out in the window. The system will trigger
the alarm-out automatically when the sensor alarm is triggered. You need to set the delay time and the schedule of the alarm outputs. See 9.4.1 Alarm-out
for details.
Preset
: check it and then the “Trigger Preset” window will pop up automatically. Configure the trigger preset of each camera. To add presets, please
see 6.2 Preset Setting for details.
Buzzer
: if enabled, the system will begin to buzz when the sensor alarm is triggered. To set the delay time of the buzzer, please see 9.4.4 Buzzer for details.
Pop-up Video
: After camera setting, the system will pop up the corresponding video automatically when the sensor alarm is triggered. To set the duration
time of the video, please see 9.4.3 Display for details.
Pop-up Message Box
: if enabled, the system will pop up the corresponding alarm message box automatically when the sensor alarm is triggered. To set the
duration time of the message box, please see 9.4.3 Display for details.
: if enabled, the system will send an e-mail when the sensor alarm is triggered. Before you enable the email, please configure the recipient’s e-mail
address first (see 11.1.4 E-mail Configuration for details).
9.2 Motion Alarm
Motion Alarm
: when the motion object appears in the specified area, it will trigger the alarm. You should enable the motion of each camera first and then set
the alarm handling of the camera to complete the whole configuration of the motion alarm.
9.2.1 Motion Configuration
1- Click Start
Settings
Camera
Motion to go to the following interface.
2- Select the camera, enable the motion and set the sensitivity and duration of the camera.
Sensitivity
: the higher the value is, the more sensitive it is to
motion. You should adjust the value according to the practical conditions since the sensitivity is influenced by color and time (day or night).
Duration
: it refers to the interval time between the adjacent motion detections. For instance, if the duration time is set to 10 seconds, once the system detects
a motion, it will go to alarm and would not detect any other motion (specific to camera) in 10 seconds. If there is another motion detected during this period,
it will be considered as continuous movement; otherwise it will be considered as a single motion.
Содержание 46241.F16H
Страница 122: ...120 EN ...
Страница 123: ...121 EN ...
