45
2.5.2 Use Mouse
During live:
Double-click on any camera window to see the full screen. Double-click again to return to the previous screen.
Right click to reveal the control menu on the screen. Right click again to hide the menu.
In Configuration:
Click to enter a particular option. Right click to cancel the option or to return to the previous menu.
In order to input a value in a particular screen, move cursor to the input box and click. An input window will appear as in Digital Numbers and Letters Input
Window. It supports digits, alphabets and symbols input. Click “Shift” button to input capital letters and symbols; click “Shift” button again to return.
It supports mouse drag. Take motion detection area setup for example: Click customized, hold down the left button and drag to set motion detection area.
Digital Numbers and Letters Input Window
2.4 Remote Controller
It uses two AAA size batteries.
•
Open the battery cover of the Remote Controller.
•
Place batteries. Please take care of the polarity (+ and -).
•
Replace the battery cover.
The interface of remote controller is shown in Remote Controller.
Key points to check in case the remote doesn’t work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any masking.
4. Check the ID of the remote with respect to the NVR.
If it still doesn’t work, please try using a good known remote, or contact your dealer.
2.5 Control with Mouse
2.5.1 Connect Mouse
It supports USB mouse through the ports on the rear panel.
If mouse is not detected or doesn’t work, check below steps:
1. Make sure the mouse is plugged in the USB mouse port.
2. Try with a good know mouse.
REC
Record manually
Search
To enter search mode
MENU
To enter menu
Exit
To exit the current interface
ENTER
To confirm the choice or setup
Direction button
To move cursor in setup
ZOOM
To zoom in
PIP
To set picture in picture
To control playback. Play/Pause/Stop/Previous Section/Next Section/Rewind/Fast Forward
Multi
To choose multi screen display mode
Next
To switch between single picture and picture group
SEQ
To go to auto dwell mode
INFO
Get information about NVR like firmware version, HDD information
EN
