GB
64
Underneath existing work top
(
When fitting beneath a work top.) In most modern fitted
kitchens there is only a single work top under which cabinets
and electrical appliances are fitted. In this case remove the
dishwasher work top by removing the screws below the rear
edge of the top (a).
Attention
After removing the work top, the screws must be screwed
back in under the rear edge of the top (b).
The height of the dishwasher will then be reduced to 815
mm, as prescribed in the ISO standard, and the dishwasher
should fit perfectly under the kitchen working top.
Integrated installation (for the
integrated model)
Step 1. Selecting the best location for the dishwasher
The installation position for the dishwasher should be near
the existing inlet and drain hoses and the power socket.
The illustrations below show the cabinet dimensions and the
recommended installation position for the dishwasher.
1. The gap between the top of the dishwasher and
cabinet, and between the edge of the outer door and
the edge of the cabinet should not be less than 5 mm.
2. If the dishwasher is installed in a corner cabinet there
should be some space when the door is opened.
Dishwasher
Door of
dishwasher
Minimum
space of 50
mm
Cabinet
NOTE
:
Depending on where your electrical outlet is, you may
need to cut a hole in the side of the nearest cabinet.
Step 2. Cover panel dimensions and installation
The dimensions of the wooden cover panel should be
adjusted to match the installation drawings.
Semi-integrated model
Apply double-sided adhesive tape to the door of the
dishwasher as shown in figure B, then press the cover panel
into the correct position. After positioning he panel, secure it
to the door using the four long screws (See figure B).
Fully integrated model
Install the hook on the wooden cover panel and engage the
hook in the slot on the door of the dishwasher (see figure
A). After positioning he panel, secure it to the door using the
four long screws (See figure B).
Step 3. Adjusting the door spring tension
1. The door springs are set at the factory to the correct
tension for the outer door. If a wooden cover panel is
fitted, you will have to adjust the door spring tension.
Rotate the adjusting screw to tighten or relax the steel
cable.
2. The door spring tension is correct when the door
remains horizontal in the fully opened position, but rises
to the closed position with slight finger pressure.
Space between
cabinet bottom
and floor
Electrical, drain and
water supply line
openings
90°
-
90°
820 mm
580 mm
80
100
600 mm (for 60 cm model)
450 mm (for 45 cm model)
a
a
b
b
Double-sided
adhesive tape
A
B
Double-sided
adhesive tape
1. Remove the four short screws
2. Fit the four long screws
A
B
1. Remove the four short screws
2. Fit the four long screws