WOP-2ac-LR5. User manual
5
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
2 Device description
2.1 Purpose
The base station WOP-2ac-LR5 (hereinafter 'the device') has been designed to provide subscribers with wireless
Internet access in the range of up to 3 km and to organize wireless bridges (WDS).
The device provides access to modern interactive services: Internet, IPTV, VoIP.
The base station WOP-2ac-LR5 – an up-to-date flexible solution that provides extending coverage zone due to the
power of its transmitter (up to 28 dBm) and the use of sectoral antennas. It is possible to deploy wireless IT
infrastructure fast and easily by virtue of high-performance hardware, scalability and intuitive interface.
The PoE+ technology makes it possible to install the equipment anywhere, regardless of the power supply
location, reduces total cost by discarding power cables and makes installation easier and faster.
2.2 Device specification
Interfaces:
1 Combo port 10/100/1000BASE-T (Ethernet)/100/1000Base-X (SFP);
2 SMA (female) connectors for external antennas. The choice of a model depends on the intended use of
the access point: for wireless bridges, it is preferable to choose narrow-band antennas, and in the base
station mode, sectoral antennas with a wider directional pattern are should be chosen;
Wi-Fi 5-6 GHz IEEE 802.11a/n/ac.
The power is supplied via a PoE injector (IEEE 802.3at-2009).
Functions:
WLAN capabilities:
support for IEEE 802.11a/n/ac;
data aggregation, including A-MPDU (Tx /Rx) and A-MSDU (Rx);
WMM-based priorities and packet planning;
support for hidden SSID;
4 virtual access points;
external
access points detection;
APSD;
spectrum analyzer;
support for wireless bridges (WDS);
Polling;
support for fixed center frequency.
Network functions:
autonegotiation of speed, duplex mode and switching between MDI and MDI-X modes;
support for VLAN (Access, Trunk, General);
authentication support 802.1X;
DHCP client;
ACL;
support for NTP;
support for Syslog.
QoS functions:
bandwidth limiting for each SSID;
client data rate limiting for each SSID;
changing WMM parameters for each radio interface;
support for CoS and DSCP prioritization;