WOP-2ac-LR5. User manual
34
•
•
•
•
•
•
•
•
•
•
•
•
•
4.8 The 'Network Settings' menu
4.8.1 The 'System Configuration' submenu
Hostname
– nertwork name of the device specified by a string from 1 to 63 characters; latin uppercase and
lowercase letters, numbers, hyphen '-' (hyphen can not be the last character in the name);
Management VLAN
:
Disabled
– Management VLAN is not used;
Terminating
– the mode where the management VLAN is terminated at the access point; in this case,
clients connected via the radio interface do not have access to this VLAN;
Forwarding
– the mode where the management VLAN is also transmitted to the radio interface (with
the appropriate VAP configuration).
VLAN ID
– the VLAN ID used to access the device, takes values 1-4094;
Protocol
– protocol that will be used to connect the device to service provider network via Ethernet
interface:
DHCP
– operation mode where IP address, subnet mask, DNS server address, defualt gateway and
other parameters required for operation are obtained from DHCP server automatically;
Static
– operation mode where IP address and all the necessary parameters for WAN interface are
assigned statically. If «Static» is selected, the following parameters will be available to configure:
Static IP
– device WAN interface IP address in the provider network;
Netmask
– external subnet mask;
Gateway
– address to which a packet is sent, if the route has not been found in a routing table;
Primary DNS server, Secondary DNS server
–
IP addresses of DNS servers. If DNS servers' addresses
are not allocated automatically via DHCP, set them manually.
To apply a new configuration and save settings to non-volatile memory, click «Apply». Click «Cancel» to discard
the changes.
