WOP-2ac-LR5. User manual
37
•
•
•
4.9 The 'System' menu
In 'System' submenu, configuration of system, time, access to the device via different protocols as well as
password change and software update can be performed.
4.9.1 The 'Device Firmware Upgrade' submenu
The 'Device Firmware Upgrade' submenu is used to update the device firmware.
Active Version
– firmware version installed on the device and operating at the moment;
Backup version
– firmware version installed on the device which can be used in case of problems without
downloading a firmware file;
Set active
– a button that makes a backup version of the firmware active; this will require a reboot of
the device. The active firmware version will be set as a backup.
Firmware update
Download the firmware file from
http://eltex-co.com/support/downloads/
and save it to your computer. To do this,
click the 'Choose file' button in the
Firmware Image
field and specify the path to the firmware file in .tar.gz format.
To start the update process, click the 'Start Upgrading' button. The process may take several minutes (its current
status will be shown on the page). The device will be automatically rebooted when the update is completed.
Do not switch off or reboot the device during the firmware update.
In case of upgrading from firmware version 1.2.0 to 1.3.0 firmware version, it is necessary to reset the
device to factory settings and reconfigure it according to the usage pattern after the firmware update.
If the firmware is rolled back from version 1.4 or 1.5 to the 1.3 or lower version, the configuration of the
radio interface may be incompatible, therefore, it will be changed. Perform the setup again and then
enable the VAP/SSID.
