ELTEX SMG-2, Руководство по эксплуатации, Страница: 45 / 198

SMG digital gateway 45
–
When an IAM (the SS7 protocol) or SETUP (the PRI protocol) message received with redirection
information—the number from the Redirecting Number field.
–
When message 302 (the SIP protocol) is received—the number from the To field.
When the Save Redirection Tag checkbox is checked, the following field is added for redirected calls:
;2013-10-09 17:58:26;5;16;user answer;192.168.0.2;trunk-
SIP;TrunkGroup01;650000;650000;1;1;001;001;0.0.0.0;trunk-SS7;TrunkGroup00;650023;650023;2013-10-09
17:58:24;2013-10-09 17:58:31;
redirecting ;
where
redirecting —a redirection tag.
The redirection tag may have the following values:

redirecting —the caller has redirected the call to the callee;

redirected —the call initiated by the caller has been redirected to another subscriber.
4.1.5 E1 Streams
This section
6
describes configuration of signalling and parameters for each E1 stream.
4.1.5.1 Signalling Protocol Selection
To select a signalling protocol for a stream, use the
Signalling Protocol drop-down list.
The device supports the following signalling protocols:

Q.931 (User, Network);

SS7 (ОКС-7);

QSIG for subscriber name transmission;

CorNet for subscriber name transmission.
4.1.5.2 Configuration of Physical Parameters
Physical settings

Enable —the stream is physically enabled.

CRC4 xmit/control —CRC4 checksum is generated
during transmission and checked during reception.

Equalizer —when checked, amplifies the
transmitted signal.

Alarm indication —when checked, a local stream
fault results in fault indication (the ALARM LED
turns on and the alarm is registered in the alarm
log).

Remote alarm indication —when checked, a
remote stream fault results in fault indication (the
6
Only one E1 stream is available in an SMG-2 device by default. To activate another one, a special licence is required. For
more information about licences, see section 4.1.19 Licence Renewal Licence Renewal.