OLT LTP-16N, LTP-16NT. User Manual
55
•
•
•
•
•
•
LTP-16N# configure terminal
LTP-16N(configure)# interface port-channel load-balance hash src-mac dst-mac vlan
LTP-16N(configure)# interface port-channel load-balance polynomial 0x9019
4.10.2.2 Port-channel configuration
Step 1.
Create an interface port-channel and pass the index as a parameter.
LTP-16N# configure terminal
LTP-16N(configure)# interface port-channel 1
LTP-16N(config)(if-port-channel-1)#
Step 2
. The port-channel settings are mostly similar to the 10G-front-port settings. For example, allow
VLANs passing:
LTP-16N(config)(if-port-channel-1)# vlan allow 100,200,300
Step 3.
Apply the configuration by using the
commit
command.
LTP-16N(config)(if-port-channel-1)# do commit
4.10.2.3 Adding ports to port-channel
Step 1.
To aggregate ports in a port-channel, you should go to the ports to be aggregated:
LTP-16N(configure)# interface 10G-front-port 3-4
LTP-16N(config)(if-front-3-4)#
Step 2.
Set the port-channel on the interfaces using the
channel-group
command
LTP-16N(config)(if-front-3-4)# channel-group port-channel 1
Step 3.
Apply the configuration by using the
commit
command.
LTP-16N(config)(if-front-3-4)# channel-group port-channel 1
Interface and port-channel configurations should be the same. If the configurations are different,
an error will occur when trying to aggregate the interfaces. If you want to force the aggregation,
you can use the
force
option for the
channel-group command.
In this case, the interfaces will be
configured from the port-channel and the current configuration will be reset.
An interface can belong to only one aggregation group.
After changing the port-channel settings, the terminal will be automatically reconfigured. There
may be a temporary stoppage of services.