OLT LTP-16N, LTP-16NT. User Manual
32
•
4.3 User management
4.3.1 Introduction
This section is devoted to management of the terminal users.
For security reasons, there is a strictly defined set of permissions, which can be delegated to terminal users.
For these purposes, each user gets his own privilege level. Level 0 corresponds to a minimum set of
permissions, Level 15 — to a maximum set of permissions. Levels 1 to 14 are fully configurable. For ease of
use, these levels are filled with default privileges.
The CLI commands are divided into access levels according to the block they change or let you view.
Commands without access level (exit, !) are available to all users. Level 15 commands are available only to
Level 15 users. Thus, the level of commands available to a user does not exceed the user's level.
Privilege configuration
Step 1.
The default privilege allocation can be viewed by using the
show running-config privilege all
command.
LLTP-16N# show running-config privilege all
privilege 1 view-interface-ont
privilege 2 view-interface-ont
privilege 2 commands-interface-ont
privilege 4 view-interface-ont
privilege 4 config-general
privilege 4 config-interface-ont
privilege 4 commands-interface-ont
privilege 4 commands-configuration
privilege 5 view-interface-ont
privilege 5 config-general
privilege 5 config-interface-ont
privilege 5 config-interface-ont-profile
privilege 5 commands-interface-ont
privilege 5 commands-configuration
privilege 6 view-interface-ont
privilege 6 config-general
privilege 6 config-interface-gpon-port
privilege 6 config-interface-ont
privilege 6 config-interface-ont-profile
The factory settings provide only one user, i. e. the device administrator.
login: admin
password: password
When you start to configure the terminal, we recommend you to change the password of the 'admin'
user.
