OLT LTP-16N, LTP-16NT. User Manual
25
•
•
•
•
Step 4.
Log into the terminal CLI.
Trying 192.168.1.2...
Connected to 192.168.1.2. Escape character is ’^]’.
********************************************
* Optical line terminal LTP-16N *
********************************************
LTP-16N login: admin
Password:
LTP-16N#
3.1.4 Connecting to CLI via Secure Shell protocol
Secure Shell connection (SSH) has functionality similar to the Telnet protocol. However, as opposed to Telnet,
Secure Shell encrypts all traffic data, including passwords. This enables secure remote connection via public
IP networks.
This section considers direct connection to CLI at the terminal location. Remote connection is similar, but
requires changes in the terminal IP address that will be considered in detail in the
section.
In order to be connected to the terminal, a PC should have a Network Interface Card (NIC). The PC should have
an SSH client installed, e. g. PuTTY. The connection will additionally require the sufficient amount of network
cable (Patch Cord RJ-45) as it is not included in the delivery package.
Step 1.
Perform steps 1 and 2 from the
Connecting to CLI via COM port
Step 2.
Run PuTTY. Enter IP address of the terminal. The factory setting for the IP address is
168.1.2
.
Select port
22
and
SSH
protocol type. Click
<Open>
.
Step 3.
Log into the terminal CLI. Factory authorization settings:
login:
admin
, password:
password
.
login: admin Password: ********
LTP-16N#
3.2 Getting Started with terminal CLI
3.2.1 Introduction
CLI is the main means of communication between user and the terminal. This section describes general CLI
procedures, with information on grouping, autocomplete options, and command history.
3.2.2 CLI views hierarchy
The command system of the LTP-16N command line interface is divided into view sections. The transition
between sections is performed by commands. The
exit
command is used to return to the previous level. Some
views are an array where a unique index must be used to access a specific object.
Figure 13 shows a graphic chart of main views and the commands to switch between them.
Factory authorization settings:
login:
admin
, password:
password
.
