Eltako – The System in the Building – Operating manual for Series 14 RS485 bus DIN rail mounted devices
27
Powerline Gateway FPLG14
Operating principle:
This gateway translates wireless and Powerline telegrams in both directions. When you use the GFVS visualisation software, we
recommend connection using an FGW14-USB!
All
Powerline telegrams from the electricity wiring system are automatically translated into RS485 bus telegrams and may also be
sent as wireless telegrams by connected FTD14 devices.
Only
wireless and RS485 bus telegrams taught into the FPLG14 are translated into Powerline telegrams and modulated onto the
electricity wiring system. Up to 120 different addresses. Teach-in takes place by means of rotary switches on the front of the devices
or using the PCT14 as described in the user‘s manual.
Connections:
This device needs 230 V as power supply. Over this connection are also sent the Powerline signals. All HOLD terminals from the
devices on the bus must be connected together.
The bus communication (regulation of the bus access, against collision) will only work correctly if this connections are done. The
ENABLE terminal must only be connected to the HOLD terminal if the bus is working without FAM14.
Assign device address for FPLG14:
To be ready to work, an address must be assigned from the FAM14 to the FPLG14. Set the rotary switch on the FAM14 to position
1, its lower LED flashes red. Set the lower rotary switch of the FPLG14 to ADR. The LED flashes at a low rate. Once the address has
been assigned by the FAM14, its lower LED flashes green for 5 seconds and the LED of the FPLG14 goes out.
Assigning a domain (home address):
Switch on the main fuse. The red LED below the left rotary switchof the unconfigured FPLG14 flickers. Press the pushbutton (switch)
of apreviously installed and configured Powerline device
5 times (10 times)
within 5 seconds. The actuator/sensor input transfers
its domains (home address) to the FPLG14.
PL-address range
The address is configurable on the PL devices with 2 rotary switches. 15 group addresses (g) and 16 element addresses are
available.
With the software Sienna-Professional
®
, the element addresses (e) from 1 to 127 are configurable. This address range can also be
controlled from the FPLG14. With the software Sienna-Professional
®
, the group adress (g) A to Z are configurable.
The FPLG14 can
only control group adresses from A to O.
(A notification appears in the software Sienna-Professional)
10. Powerline gateway FPLG14
Function rotary switches
Standard setting ex works.
Powerline gateway FPLG14
