10
Installation and commissioning
Wind Sensor KNX W
• Date of issue: 31.10.2012 • Technical changes reserved. Errors reserved.
24 V DC version
2.3.5. Mounting the weather station
Close the housing by putting the cover back over the bottom part. The cover must snap
in on the left and right with a definite “click”.
Fig. 12
1
Opening for the cable connec-
tion to the cover
2
Tension clamp for voltage
supply (230 V AC), suitable for
massive conductors of up to
1.5 mm² or conductors with
fine wires
3
Opening for the cable for the
voltage supply and for the bus
cable
4
Slot for KNX clamp +/-
5
Programming pushbutton for
the teach-in of the device
6
Programming LED
1
2
4
3
5
6
Fig. 13
Make sure the cover and bottom part are
properly snapped together! This picture is
looking at the closed sensor from under-
neath.
Fastening
