elsner elektronik KNX RF-MSG-DST, Установка и настройка

Страница: 22 / 26

20 Parameter setting
Radio actuator KNX RF MSG-DST Version: 27.06.2018 • Technical changes and errors excepted.
Movement limits
The menu item appears only if a movement limit was activated in ‘Control’. Movement
limits can be used to restrict manual movement. The limit is active for object value 1.
If limiting the movement position:
If limiting the slat angle (shutters only):
4.3.1. Manual
Position memory for the manual movement can be activated here. The position set
here can be overwritten via a learning object at any time. The memorised position can
be retrieved again at a later time.
For shutters, both the movement and the slat position can be stored.
Position in % (only if by using a block, a
specific position is achieved)
0...100
Slat position in % (only if by using a block,
a specific shutter position is achieved) 0...100
Waiting period in secure position in min
after blocking 1...255; 5
Behaviour after waiting period
For manual operation before and after
blocking • no action
• move into last position
For automatic operation after blocking follow automatic
Limitation type • completely
• movement position
• slat angle (for shutters)
• allow UP only
• allow DOWN only
Value of the object in front of 1.
Communication and bus voltage
restoration 0 • 1
Limitation type • movement position
Movement allowed in the position range
from (in %) 0...100
to (in %) 0...100
Limitation type • slat angle
Movement allowed in the angle range
from (in %) 0...100
to (in %) 0...100
Use position memory no • yes