elsner elektronik KNX RF-MSG-DST, Установка и настройка

Страница: 16 / 26

14 Parameter setting
Radio actuator KNX RF MSG-DST Version: 27.06.2018 • Technical changes and errors excepted.
If the short time command for shutters (step command) is used only for slat
adjustment, but not for positioning the curtain, the following parameter is set to "Yes".
The parameter appears only for shutters.
Break time:
The required break times during a change of direction of the drive should be adjusted
according to the specifications of the motor manufacturer.
Reference movement:
With the regular movement to the two end positions the runtime is adjusted again.
This is especially important for the automatic runtime determination. Therefore, it can
be set here after how many movements before a positioning movement a reference
movement will be performed. The reference movement is always in the direction of the
secure position (retracting when shading, closing windows).
Slat turning:
(only for shutters)
The slat turning should be adjusted according to the specifications of the motor manu-
facturer.
Status object and drive position:
The status and current position can be sent to the bus. By sending of 1, the status ob-
ject indicates that the retracted or closed position has been exited and it is suitable for
example for monitoring windows.
The exact drive position can be sent on the bus if required. The variable delay ensures
Step time in 10 ms 1 … 100; 20
Step number slats 1 … 255; 5
Allow step commands only for slat
adjustment no • yes
Break time for a change of direction
in 0.1 sec 5 … 100; 10
Perform a reference movement no • yes
Perform a reference movement yes
for more than
movements before an auto positioning
movement 1 ... 255; 10
Turn slats • never
• only after positioning movement
• after each movement