elsner elektronik KNX LW sl 70164, Установка и настройка

Страница: 39 / 42

37 Parameter setting
Brightness and Wind Sensor KNX LW sl • Status: 19.08.2021 • Errors excepted. Subject to technical changes.
Block
If necessary, activate the block for the logic output and set what a 1 or 0 at the block
input means and what happens in the event of a block.
Monitoring
If necessary, activate the input monitoring. Set which inputs are to be monitored, at
which intervals the inputs are to be monitored and what value the "monitoring status"
should have, if the monitoring period is exceeded without a feedback being given.
6.9.2. AND logic connection inputs
Do not use
Logic input 1
Logic input 1 inverted
Logic input 2
Logic input 2 inverted
Logic input 3
Logic input 3 inverted
Logic input 4
Logic input 4 inverted
Logic input 5
Logic input 5 inverted
Logic input 6
Logic input 6 inverted
Logic input 7
Logic input 7 inverted
Use block No • Yes
Analysis of the blocking object • At value 1: block | At value 0: release
• At value 0: block | At value 1: release
Blocking object value before first call 0 • 1
Output pattern
On block • Do not send message
• Transmit block value [see above,
Output value if blocking active]
On release
(with 2 seconds release delay) [send value for current logic status]
Use input monitoring No • Yes
Input monitoring • 1 • 2 • 3 • 4
• 1 + 2 • 1 + 3 • 1 + 4 • 2 + 3 • 2 + 4 • 3 + 4
• 1 + 2 + 3 • 1 + 2 + 4 • 1 + 3 + 4 • 2 + 3 + 4
• 1 + 2 + 3 + 4
Monitoring period 5 s • ... • 2 h; 1 min
Output behaviour on exceeding the moni-
toring time • Do not send message
• Send value exceeding [= value of the
parameter "monitoring period"]