30
Parameter setting
Actuator KNX S1R-BA4-UP 24 V
• Version: 27.05.2020 • Technical changes and errors excepted.
Movement limits
The menu item appears only if a movement limit was activated in ‘Control’. Movement
limits can be used to restrict manual movement. The limit is active for object value 1
If limiting the movement position:
If limiting the slat angle (shutters only):
6.2.1.2.Manual
Position memory for the manual movement can be activated here. The position set
here can be overwritten via a learning object at any time. The memorised position can
be retrieved again at a later time.
For shutters, both the movement and the slat position can be stored.
Limitation type
• full
• movement position
• slat angle (for shutters)
• allow UP only
• allow DOWN only
Value of the object in front of 1.
Communication and bus voltage
restoration
0 • 1
Limitation type
• movement position
Movement allowed in the position range
from (in %)
0...100
to (in %)
0...100
Limitation type
• slat angle
Movement allowed in the angle range
from (in %)
0...100
to (in %)
0...100
Use position memory
no • yes
Use different positions for object values 0
and 1
no • yes
(if ‘yes’ is selected, there will be a division
into positions for object value 0 and object
value 1)
Position in %
0...100
Allow calling via command sequence: long-
term = 1, short-term = 1
no • yes
Use learning object for new position
no • yes
Transfer when programming
(when learning object is used)
• all parameters
• changed parameters only
