elsner elektronik 70391, Установка и настройка

Страница: 14 / 18

12 Parameter setting
Door operator control module KNX A3-B2 • Status: 17.12.2019 • Technical changes and errors reserved.
Input 8 bit encoder:
If the input is to be used as an 8bit encoder, select the "8 bit encoder" bus function and
specify which value will be sent.
Input as temperature encoder:
If the input is used as a temperature encoder, then choose the bus function
"Temperature encoder" and specify which value between -30°C and +80°C will be sent.
By sending a temperature value, the target value of the temperature control may be
changed for example.
Input as brightness encoder:
If the input is assigned and shall be used as a brightness encoder (e.g. threshold value
of a sun sensor), select "brightness encoder" and specify which value will be sent.
Input for scene control:
If scenes are called and saved with the input, then choose the "Scenes" bus function
and specify the saving, time difference (call/save) and scene number.
Repeat the dimm command
for a long button press
(if dimm command is repeated)
every 0.1 s • every 2 sec; every 0,5 sec
Dim by
(if dimm command is repeated)
1,50% • 3% • 6 % • 12,50% • 25% • 50%
Function 8 bit encoder
Value 0...255
Function Temperature encoder
Temperature in 0.1°C -300...800; 200
Function Brightness encoder
Brightness in klux 0...100; 20
Function Scenes
Button operation • without saving
• with saving
Time between calling and saving in 0.1
seconds
(only if selected "with saving")
1...50; 10
Scene No. 0...127