elsner elektronik 70391, Установка и настройка

Страница: 15 / 18

13 Parameter setting
Door operator control module KNX A3-B2 • Status: 17.12.2019 • Technical changes and errors reserved.
Control modes for drive control
Standard:
If briefly operated, the drive will move incrementally or stops. If operated longer, the
drive will move up to the end position. The time difference between "short" and "long"
is set individually.
Standard inverted:
When pushed shortly, the drive moves up to the end position. When pushed for longer,
the drive moves incrementally or stops. The time difference between "short" and
"long" and the repeat interval is set individually.
Comfort mode:
In the comfort mode actuating the button briefly, a bit longer and long will trigger
different responses of the drive. The time intervals are set individually.
Short actuation (shorter than Time 1): The drive is positioned step-wise and stopped.
Holding it slightly longer (longer than Time 1, but shorter than Time 1+2): Drive
running. Drive stops when the button is released.
Long holding (release after Time 1+2 runs out): Drive moves independently to the end
position. The movement can be interrupted by a short tap.
Control mode Standard
Behavior during button operation:
short = stop/increment long = Up or Down
Time between short and long
in 0.1 seconds 1...50; 10
Control mode Standard inverted
Behavior during button operation:
short = Up or Down long = Stop/Step
Time between short and long
in 0.1 seconds 1...50; 10
Repeat the step command
for a long button press every 0.1 s • every 2 sec; every 0.5 sec
Point in time 0: Actuate of button, start of time 1
Release before time 1 expired: step (or stop if drive is moving)
Point in time 1: End of time 1, start of time 2
Moving command
Time 1 Time 2
0 1 1 + 2
Fig. 4
Time interval comfort mode diagram